Installation guide
Table Of Contents
- SAGEM F@stTM 2604 SAGEM F@stTM 2644
- 1. Introduction
- 2. Description and connection of router
- 3. Installing and configuring the SAGEM F@stTM 2604/2644 router
- 4. Configuration of network parameters
- 5. Information / Configuration
- 5.1 Accessing the welcome screen
- 5.2 Recommendations
- 5.3 ADSL connection status
- 5.4 Display frame
- 5.5 Status
- 5.6 Internet Connection
- 5.7 Wireless
- 5.8 NAT
- 5.9 Advanced Setup
- 5.10 Advanced Status
- 5.11 Management
- 6. Internet access service
- 7. TV over ADSL service
- 8. Updating the firmware
- A. Annex A - Troubleshooting
- B. Annex B - Warnings for safety
- C. Annex C - Environment
- D. Annex D - Technical Characteristics
- E. Annex E - Default configuration
- F. Annex F - Glossary
- G. Annex G - Connector Technology
5 - Information / Configuration
SAGEM F@st™ 2604/2644 Reference Manual - 253080888-A
Page 5-98 Sagem Communications document. Reproduction and disclosure prohibited
5.9.5 Routing
This menu contains 3 sub-menus:
• Default Gateway (see subsection 5.9.5.1),
• Static Route (see subsection 5.9.5.2),
• RIP (see subsection 5.9.5.3).
5.9.5.1 Default Gateway
Object: This menu is used either to allocate dynamically a default gateway address to the
router from a PVC or to enter an address or choose an interface.
• Select the Default Gateway sub-menu in the Routing menu in the Advanced Setup
section to display the following screen:
Field Action Default
EnableAutomatic Assigned
Default Gateway
Check the box to allocate automatically a
default gateway for your router.
Box checked
Use Default Gateway IP
Address
11
Check the box to use a default address.
Box checked
Not empty
Use Interface
11
Select the interface you want to use from
the scroll down list (pppoe_8_35_1 for
example).
Box
not checked
Interface
used
11
this field only appears when the "Enable Automatic Assigned Default Gateway" field is deactivated (box not
checked).