Installation guide

5 - Information / Configuration
SAGEM F@st™ 2604/2644 Reference Manual - 253080888-A
Sagem Communications document. Reproduction and disclosure prohibited Page 5-97
Field Action
Physical LAN Port
Select Blank or the interface of your choice
(ENET(1-4), Wireless or Wireless_Guest) from the
scroll down list.
Protocol
Select Blank or the protocol of your choice from the
scroll down list (TCP/UDP, TCP, UDP or ICMP).
Differentiated Services
Code Point (DSCP)
Check
Select the type of Differentiated Services Code
Point (DSCP) mark to be allocated
(6-bit coding) from the scroll down list.
Default to CS7 : 000000 to 111000
See the first table of this chapter.
Source IP Address
Enter a "Source" IP address.
Source Subnet Mask
Enter a "Source" subnet mask.
UDP/TCP source Port
(port or port:port)
Enter a "Source" port or range of ports.
Note: For one port, for example, enter 80. For a
range of ports, enter 80:90.
Destination IP Address
Enter a "Destination" IP address.
SET-1 Destination Subnet
Mask
Enter a "Destination" subnet mask.
UDP/TCP Destination
Port
(port or port:port)
Enter a "Destination" port or range of ports.
Note: For one port, for example, enter 80. For a
range of ports, enter 80:90.
Source MAC Address
Enter a "Source" MAC address.
Source MAC Mask
Enter a "Source" MAC mask.
Destination MAC
Address
Enter a "Destination" MAC address.
Destination MAC Mask
Enter a "Destination" MAC mask.
SET-2 802.1p Priority
Select Blank or a priority value between 0 and 7
from the scroll down list.
Note: 802.1p Priority cannot be selected together
with IP traffic condition.