Installation guide
Table Of Contents
- SAGEM F@stTM 2604 SAGEM F@stTM 2644
- 1. Introduction
- 2. Description and connection of router
- 3. Installing and configuring the SAGEM F@stTM 2604/2644 router
- 4. Configuration of network parameters
- 5. Information / Configuration
- 5.1 Accessing the welcome screen
- 5.2 Recommendations
- 5.3 ADSL connection status
- 5.4 Display frame
- 5.5 Status
- 5.6 Internet Connection
- 5.7 Wireless
- 5.8 NAT
- 5.9 Advanced Setup
- 5.10 Advanced Status
- 5.11 Management
- 6. Internet access service
- 7. TV over ADSL service
- 8. Updating the firmware
- A. Annex A - Troubleshooting
- B. Annex B - Warnings for safety
- C. Annex C - Environment
- D. Annex D - Technical Characteristics
- E. Annex E - Default configuration
- F. Annex F - Glossary
- G. Annex G - Connector Technology
5 - Information / Configuration
SAGEM F@st™ 2604/2644 Reference Manual - 253080888-A
Sagem Communications document. Reproduction and disclosure prohibited Page 5-91
5.9.4.1 Queue Config
Subject: Enabling or disabling QoS on an interface.
Configuring QoS to use policy maps attached to an interface.
• Select the Queue Config sub-menu in the Quality of Service menu to display the following
screen:
Field State
Interfacename
Name of the network interface configured
(8/35 for example).
Precedence
Priority allocated to "Queue Precedence" from 1 to 3.
Queue Key
Sequence number allocated by the system, incremented
of a unit to each addition of a QoS Queue.
Enable
QoS enabled or disabled for this interface.
Note: This status can be amended starting from this
window.