Installation guide
Table Of Contents
- SAGEM F@stTM 2604 SAGEM F@stTM 2644
- 1. Introduction
- 2. Description and connection of router
- 3. Installing and configuring the SAGEM F@stTM 2604/2644 router
- 4. Configuration of network parameters
- 5. Information / Configuration
- 5.1 Accessing the welcome screen
- 5.2 Recommendations
- 5.3 ADSL connection status
- 5.4 Display frame
- 5.5 Status
- 5.6 Internet Connection
- 5.7 Wireless
- 5.8 NAT
- 5.9 Advanced Setup
- 5.10 Advanced Status
- 5.11 Management
- 6. Internet access service
- 7. TV over ADSL service
- 8. Updating the firmware
- A. Annex A - Troubleshooting
- B. Annex B - Warnings for safety
- C. Annex C - Environment
- D. Annex D - Technical Characteristics
- E. Annex E - Default configuration
- F. Annex F - Glossary
- G. Annex G - Connector Technology
5 - Information / Configuration
SAGEM F@st™ 2604/2644 Reference Manual - 253080888-A
Page 5-80 Sagem Communications document. Reproduction and disclosure prohibited
5.9.2.1 Advanced
Object: This allows to display addresses delivered by your router's DHCP server and reserve
any addresses.
• Select the LAN menu then the Advanced submenu in the Advanced Setup section to display
the following screen:
Current using IP addresses
Field Action Default
MAC Address
Displays the MAC Address of a computer
connected to your router. This computer can be
part of a LAN (Local Area Network).
00:50:DA:0C:C0:FA
IP Address
Displays the IP Address delivered by your
router's DHCP server to your computer.
192.168.1.1