Installation guide
Table Of Contents
- SAGEM F@stTM 2604 SAGEM F@stTM 2644
- 1. Introduction
- 2. Description and connection of router
- 3. Installing and configuring the SAGEM F@stTM 2604/2644 router
- 4. Configuration of network parameters
- 5. Information / Configuration
- 5.1 Accessing the welcome screen
- 5.2 Recommendations
- 5.3 ADSL connection status
- 5.4 Display frame
- 5.5 Status
- 5.6 Internet Connection
- 5.7 Wireless
- 5.8 NAT
- 5.9 Advanced Setup
- 5.10 Advanced Status
- 5.11 Management
- 6. Internet access service
- 7. TV over ADSL service
- 8. Updating the firmware
- A. Annex A - Troubleshooting
- B. Annex B - Warnings for safety
- C. Annex C - Environment
- D. Annex D - Technical Characteristics
- E. Annex E - Default configuration
- F. Annex F - Glossary
- G. Annex G - Connector Technology
5 - Information / Configuration
SAGEM F@st™ 2604/2644 Reference Manual - 253080888-A
Page 5-76 Sagem Communications document. Reproduction and disclosure prohibited
Field Action Default
Enable NAT
Check the box to activate the NAT function.
Checked
Enable Firewall
Check the box to activate the Firewall
service.
Checked
Enable IGMP Multicast
Check the box to activate the IGMP function.
Not checked
Enable WAN Service
Check the box to activate the remote
network service (WAN).
See the note of information below.
Checked
Service Name
Displays the name of the service being
configured. This name, which is allocated
automatically, is made up as follows:
Protocol_VPI_VCI_Index
For example: pppoe_pppoa_0_35_1.
Note: You may enter another service
name.
pppoe_pppoa
_0_35_1
The “Enable WAN Service” function makes it possible to disable connection types in
a list to use only the selected connection type.
Click on the Next button to continue configuring the remote network (WAN) in PPPoE/PPPoA
mode.