Installation guide
Table Of Contents
- SAGEM F@stTM 2604 SAGEM F@stTM 2644
- 1. Introduction
- 2. Description and connection of router
- 3. Installing and configuring the SAGEM F@stTM 2604/2644 router
- 4. Configuration of network parameters
- 5. Information / Configuration
- 5.1 Accessing the welcome screen
- 5.2 Recommendations
- 5.3 ADSL connection status
- 5.4 Display frame
- 5.5 Status
- 5.6 Internet Connection
- 5.7 Wireless
- 5.8 NAT
- 5.9 Advanced Setup
- 5.10 Advanced Status
- 5.11 Management
- 6. Internet access service
- 7. TV over ADSL service
- 8. Updating the firmware
- A. Annex A - Troubleshooting
- B. Annex B - Warnings for safety
- C. Annex C - Environment
- D. Annex D - Technical Characteristics
- E. Annex E - Default configuration
- F. Annex F - Glossary
- G. Annex G - Connector Technology
5 - Information / Configuration
SAGEM F@st™ 2604/2644 Reference Manual - 253080888-A
Sagem Communications document. Reproduction and disclosure prohibited Page 5-69
IP over ATM (IPoA)
Field Action Default
WAN IP Address
6
Enter the static IP address.
0.0.0.0
WAN Subnet Mask:
6
Enter a subnet mask.
0.0.0.0
Use the following default
gateway:
If you check this box, you must enter a default
gateway address.
_
Use IP Address
7
Enter the default gateway address.
_
Use WAN Interface:
7
Select the WAN interface of your choice from
the scroll down list (optional)
_
Obtain DNS server
addresses automatically
Check the box to obtain DNS server
addresses automatically.
Box
checked
Use the following DNS
server addresses:
If you check this box, you must enter DNS
server addresses.
_
Primary DNS server
8
Enter a primary server DNS Address.
_
Secondary DNS server
8
Enter a secondary server DNS Address.
_