Installation guide
Table Of Contents
- SAGEM F@stTM 2604 SAGEM F@stTM 2644
- 1. Introduction
- 2. Description and connection of router
- 3. Installing and configuring the SAGEM F@stTM 2604/2644 router
- 4. Configuration of network parameters
- 5. Information / Configuration
- 5.1 Accessing the welcome screen
- 5.2 Recommendations
- 5.3 ADSL connection status
- 5.4 Display frame
- 5.5 Status
- 5.6 Internet Connection
- 5.7 Wireless
- 5.8 NAT
- 5.9 Advanced Setup
- 5.10 Advanced Status
- 5.11 Management
- 6. Internet access service
- 7. TV over ADSL service
- 8. Updating the firmware
- A. Annex A - Troubleshooting
- B. Annex B - Warnings for safety
- C. Annex C - Environment
- D. Annex D - Technical Characteristics
- E. Annex E - Default configuration
- F. Annex F - Glossary
- G. Annex G - Connector Technology
5 - Information / Configuration
SAGEM F@st™ 2604/2644 Reference Manual - 253080888-A
Page 5-66 Sagem Communications document. Reproduction and disclosure prohibited
Field Action Default
Obtain DNS server
addresses automatically
Check the box to obtain DNS server
addresses automatically.
Box
checked
Use the following DNS
server addresses:
If you check this box, you must enter DNS
server addresses.
_
Primary DNS server
8
Enter a primary DNS server address.
_
Secondary DNS server
8
Enter a secondary DNS server address.
_
8
This field only appears when the "Use the following DNS server addresses:" field is activated (box checked).