Installation guide
SAGEM F@st™ 2604/2644
14
Safety instructions
5 SAFETY INSTRUCTIONS
Environment
The router should be installed and used inside a building.
The room temperature should not exceed 45ºC.
The router can be placed on a desktop or xed vertically in its wall mounting.
The router should not be exposed to strong sunlight or placed near a substantial source of heat.
The router should not be placed in an environment where it would be subjected to considerable
steam condensation.
The router should not be exposed to splashes of water.
The router’s casing should not be covered.
The router and its peripherals should not be used for outdoor transmissions.
Power supply source
The router’s mains adapter should not be covered.
The router comes with its own mains adapter. It should not be used with another adapter.
This class II adapter does not need to be grounded (earthed). The connection to the electrical
network should comply with the indications given on the label.
Use a readily accessible mains outlet located near the router. The power supply cord is 2 m long.
Arrange the power supply cord in such a way as to avoid any accidental power cut to the router.
The router is designed to be connected to a GG- (ground-to-ground) or GN- (ground-to-neutral)
type power supply network.
The router is not designed to be connected to an electrical installation with IT type diagram (neutral
connected to earth through an impedance).
Protection against short-circuits and leaks between phase, neutral and earth should be provided by
the building’s electrical installation. The power supply circuit for this
equipment should be tted with 16 A overcurrent protection and differential protection.
The router should be connected to the mains via a wall socket, ensuring the electric cutting is
readily accessible.
Maintenance
It is prohibited to open the casing. This must be done only by qualied personnel approved by your
supplier.
Do not use liquid or aerosol cleaning agents.
252987009-A_GIR_2604-2644 (gb).i16 16 22/05/2008 13:35:35