Installation guide
SAGEM F@st™ 2604/2644
If a test displays a «FAIL» status, click on «Help» then the «Rerun
Diagnostic Tests» button at the bottom of the «Help» page to make sure that the test was
suitable. If the test still displays «FAIL», you must follow the repair procedure displayed on
this page.
A hypertext link (help) enables the user to access contextual help. This help provides ex-
planations about the status of the connection (PASS green, DOWN orange and FAIL red)
and provides the appropriate repair procedures.
The result of the tests carried out by your router’s «DSL router» conguration tool is displayed in the
«Diagnostics» window. These tests relate to the connections to the LAN, your DSL Service Provider
and your Internet Service Provider (ISP).
IMPORTANT
If you are having trouble connecting to the Internet we recommend that you restart your router or pos-
sibly return to the factory conguration using the procedures described below.
Restarting your router
To restart your router, click on the «Reboot» button in the top right of your HTTP conguration tool’s
welcome page.
Returning to the factory conguration
To return to the factory conguration:
in the top left of your HTTP conguration tool’s welcome page select the Management heading
then the Restore default sub-menu in the Settings menu.
or press and hold for about 10 seconds on the button marked «REG» on the back of your router.
Connection status
Status Colour Meaning
PASS Green indicates that the test was carried out correctly
DOWN
Orange indicates that an interface (ETH or Wi-Fi) was not detected
FAIL
Red
indicates that a test failed or that a command could not be laun-
ched.
Troubleshooting
13
252987009-A_GIR_2604-2644 (gb).i15 15 22/05/2008 13:35:35