Installation guide

SAGEM F@st™ 2604/2644
10
4 TROUBLESHOOTING
Users can locate the fault using the following sources:
Status of the LEDs on the front,
Information accessible by your routers built-in «DSL Router» HTTP controller,
Router supervision,
«Diagnostics» tools.
4.1 STATUS OF THE LEDS ON THE LEFT OF THE
FRONT PANEL
Status Colour
Lit
steady
Green Power On ADSL up
Wi-Fi
activated
A PPP session has been
created
Amber x x x ADSL link is established
Flickering Green x x Wi-Fi Tx/Rx Tx/Rx trafc
Blinking
Amber x x x ADSL is training
Slow
Blinking
Green x Line not detected Wi-Fi pairing x
Fast
Blinking
Green x
ADSL synchronisation
training
x x
Off
Green Power Off x
Wi-Fi
deactivated
Power Off
or
Bridge mode
or
ADSL down
4.2 STATUS OF THE LEDS ON THE RIGHT OF THE
FRONT PANEL
Status Colour 1 2 3 4
Lit on steady
Green
Ethernet port (ETH1, ETH2, ETH3 or ETH4) has detected a link with
100 Mbps device
Flickering Tx/Rx trafc at 100 Mbps
Lit on steady
Amber
Ethernet port (ETH1, ETH2, ETH3 or ETH4) has detected a link with
10 Mbps device
Flickering Tx/Rx trafc at 10 Mbit/s
Off
x No link detected on the Ethernet port
252987009-A_GIR_2604-2644 (gb).i12 12 22/05/2008 13:35:34