User's Manual

s
E
Ref. : SCT TMO LOG SPEC
163
Revision : B
Sec. Ref. :
Date : 2003-01-22
E. CONFIDENTIAL All rights of reproduction and disclosure reserved.
Page 38 / 52
2.7.7 Set Full Rate
This function is used to force the mobile in Full Rate mode. The choices are:
•
Active
•
Inactive
The
OK
button (or right one-touch button) validates the choice, the
C
button (or left one-touch button)
cancels.
2.7.8 Set Band
This function is used to force the mobile on the 900 MHz or 1800 MHz band. The available choices are:
•
900
•
1800
•
Inactive
The
OK
button (or right one-touch button) validates the choice, the
C
button (or left one-touch button)
cancels.
After the validation, the mobile must be powered off and on so that the new setting of the forcing
can be taken into account.
2.7.9 Set Cell Reselection
2.7.9.1 Activation/Deactivation screen
This screen is used to activate or deactivate the Set Cell Reselection function. The possible choices are:
•
Active
: the mobile will attempt to camp on a given frequency, using the Cell Re-selection procedure
•
Inactive
: the Cell Reselection forcing is deactivated
•
None
: this choice suppresses Cell Re-selection, i.e. the mobile will not use the Cell Re-selection
procedure, whatever happens.
The scroll push-buttons
^
and
v
are used to browse through these choices.