User's Manual

s
E
Ref. : SCT TMO LOG SPEC
163
Revision : B
Sec. Ref. :
Date : 2003-01-22
E. CONFIDENTIAL All rights of reproduction and disclosure reserved.
Page 24 / 52
2.5.2 PDP Context
These screen give information about the parameters that are negotiated between the network and the
mobile station at PDP Context activation. The scroll push-buttons
^
and
v
are used to browse through the
successive screens. The total number of screens depends on the maximum allowed number of concurrent
PDP Context. There are 2 screens for each PDP context.
2.5.2.1 PDP Context 1
st
screen
•
SM
: SM Service State for the PDP Context. If SM = INA or ACP, all the other parameters of both
screen are invalid for this PDP Context (except for the NSAPI parameter which is also valid when in
Active Pending SM state)
!
INA
: Inactive
!
ACP
: Active Pending
!
INP
: Inactive Pending
!
ACT
: Active
•
NSAPI
: Network Service Access Point Identifier for the PDP Context.
5
to
15
•
LLC SAPI
: LLC Service Access Point Identifier for the PDP Context.
3
,
5
,
9
or
11
•
RAD PR
: Radio Priority for the PDP Context. Ranges from
1
(highest priority) to
4
(lowest priority)
•
IP
: IP address associated to the PDP Context.
4
bytes displayed in decimal
2.5.2.2 PDP Context 2
nd
screen
•
DLY
: Delay Class. Ranges from
1
to
4
(best effort)
•
RLY g-l-r-p
: Reliability Class
!
g
: GTP mode (
A
: Acknowledged,
U
: Unacknowledged)
!
l
: LLC mode (
A
: Acknowledged,
U
: Unacknowledged)
!
r
: RLC mode (
A
: Acknowledged,
U
: Unacknowledged)
!
p
: data protection (
P
: Protected Data,
U
: Unprotected Data)
•
PRE
: Precedence Class