User's Manual

s
E
Ref. : SCT TMO LOG SPEC
163
Revision : B
Sec. Ref. :
Date : 2003-01-22
E. CONFIDENTIAL All rights of reproduction and disclosure reserved.
Page 13 / 52
2.4.4 NEIGHBOURING CELL Second screen in IDLE mode
This screen gives additional GSM Cell Reselection information along with information about the GPRS
capability of the Neighbouring Cell:
- CRH: 0 to 14 dB, 2 dB steps
Current value of CELL RESELECT HYSTERESIS for the Neighbouring cell
- CRO: 0 to 126 dB, 2 dB steps
Current value of CELL RESELECT OFFSET for the Neighbouring cell
- PY: 20 to 620 s, 20 s steps. None
if no Temporary Offset is used
Current value of PENALTY TIME for the Neighbouring Cell
- TMP: 0 to 60 dB, 10 dB steps. Inf
for Infinite Temporary Offset
Current value of TEMPORARY OFFSET for the Neighbouring Cell
- GPRS: Yes or No
Indicates whether the Neighbouring Cell supports GPRS or not
- RA COL: 0 to 7
Current value of RA Colour for the Neighbouring Cell. Only valid if the Neighbouring Cell supports
GPRS
2.4.5 SERVING CELL screen in DEDICATED mode
This screen supplies synthetically the values of the main parameters received from the network, concerning the
serving cell. The
icon indicates that the mobile is in dedicated mode.
- TCH : cha
or
HP
Current TCH ARFCN (Traffic channel number). When the network uses FREQUENCY
HOPPING, the channel number is replaced by the indication HP.
- TS : 0
to
7
Current TIME SLOT number.
- TA : 0 to 63
Current value of the TIMING ADVANCE expressed in number of bit times.
To convert the displayed value into µs, simply multiply it by 3.69.
- DTX : Y
or
N
The DTX (Discontinuous Transmission) mode is used for uplink Yes (
Y
) or no (N).
-
BSIC : ab