User's Manual

s
E
Ref. : SCT TMO LOG SPEC
163
Revision : B
Sec. Ref. :
Date : 2003-01-22
E. CONFIDENTIAL All rights of reproduction and disclosure reserved.
Page 10 / 52
2.4 NETWORK
This function is used to display the values of the main parameters received from the serving cell and six
neighbouring cells, in standby mode (IDLE) as well as in dedicated mode .
You can dial while in the trace screens by keying the digits of the remote number followed by the
✆
✆✆
✆
key.
After starting the call, the mobile display will automatically return to trace screen. You can also call the last
number dialed by pressing the
✆
✆✆
✆
key.
Data are displayed in 2 screens for each cell, i.e. up to 14 successives screens.
To browse through the successives screens, press the scroll push-buttons:
^
Next screen and
v
Previous
screen.
From these screens, you can display additional screens by pressing the
Ok
key.
When the reception conditions prevent decoding of some information received from the network, the
values of the corresponding parameters are replaced by “-“.
2.4.1 SERVING CELL Main screen in IDLE mode
This screen displays synthetically the values of the main parameters received from the network, concerning the
serving cell:
- BCCH :
Current ARFCN of the BCCH (channel number).
- TS : 0 to 7
Current TIME SLOT number (TS is 0 in idle mode).
- BA : nm x.y
Number of elements in the BA list.
nm 1
to
32
CCCH configuration on BCCH and PCH:
x2
to
9
Current value of BS_PA_MFRMS
y 0, 1, 2, 4
or
6
Current value of CCH_CONF
- BSIC : ab
Current value of the BSIC (Base Station Identity Code) for the serving cell:
a0
to
7
Digit corresponding to the operator code (NCC).
b0
to
7
Digit corresponding to the cell colour code (BCC).
- TX :
Current value of MS_TXPWR_MAX_CCH for the serving cell.