User's Guide

84
SAGEM Sécurité document. Reproduction and disclosure forbidden
T
T
A
A
M
M
P
P
E
E
R
R
S
S
W
W
I
I
T
T
C
C
H
H
M
M
A
A
N
N
A
A
G
G
E
E
M
M
E
E
N
N
T
T
A
A
l
l
a
a
r
r
m
m
a
a
c
c
t
t
i
i
v
v
a
a
t
t
i
i
o
o
n
n
The MorphoAccess
TM
can detect two intrusion attempts type:
• Someone tries to steal the complete terminal (opto-sensor is
triggered).
• Someone tries to open the terminal (tamper switch is triggered).
The device can send an alarm to the central controller in case of intrusion.
It can also play a sound alarm while sending the alarm.
Note: either the tamper switch or the opto-sensor triggers the alarm.
Please refer to MA500 Series Installation Guide to identify these switches
on the terminal.
To send an alarm on an output (UDP, RS485/RS422, Wiegand,
DataClock), the corresponding interface must be activated otherwise no
alarm will be sent.
Because Wiegand and DataClock are multiplexed on the same lines, only
one of these protocols shall be enabled at one time, else priority is given
to Wiegand, then DataClock.
These keys are:
app/send ID wiegand/enabled
app/send ID dataclock/enabled
app/send ID serial/enabled
app/send ID serial/mode (to select RS422 or RS485 link)
app/send ID UDP/enabled
Alarm message
UDP
RS485/RS422
Wiegand
DataClock