User's Guide

48
SAGEM Sécurité document. Reproduction and disclosure forbidden
D
D
a
a
t
t
a
a
b
b
a
a
s
s
e
e
n
n
u
u
m
m
e
e
r
r
a
a
t
t
i
i
o
o
n
n
MA-Xtended licence extends biometric database capacity from 1 base of
3000 users to 5 bases of 10000 users. In this configuration the user must
select his database number (from 0 to 4) before presenting a finger to
launch identification process.
For user convenience MorphoAccess™ 300 series it is also possible to
activate a “16 databases mode”. In this mode the user selects a database
number between 0 and 15, and presents a finger to launch identification
process. Database selection
The base identification is a two digit number, with a leading zero when
required. The default selected base is the base with the identification is
“00”.
Pressing a decimal key changes the base to use by modifying the current
identification number: the higher digit is replaced by the unit digit and the
unit number is replaced by the entered digit. It means that is the “x” key is
pressed while the selected base number is “yz”, then the new selected
base will be “zx”, if it exists.
Valid base numbers are from 00 to 15, then if the selected base number is
higher than “15”, then the number of the default base (00) is automatically
forced.
Key
allows to select a database from 10 to 15. For To select database
13 press
then , just press a key number to toggle the database
number. By default, databases 0 to 4 can be selected and used.
Access control by identification with MA-Xtended licence
app/bio ctrl/identification 1
From the terminal point of there is still 5 biometric databases.
MorphoAccess™ 300 series
Or
MorphoAccess™ 500 series
MorphoAccess™ 500 series
(MA-Xtended licence)
Database
0,1,2 0
3,4,5 1
6,7,8 2
9,10,11 3
12,13,14,15 4