User's Guide

24
SAGEM Sécurité document. Reproduction and disclosure forbidden
MorphoAccess
TM
500 can only be configured in identification mode (other
modes could be configured later).
MorphoAccess
TM
520 can be configured in identification mode, contactless
authentication or multi-factor mode (identification and contactless
authentication modes are merged ).
O
O
u
u
t
t
p
p
u
u
t
t
i
i
n
n
t
t
e
e
r
r
f
f
a
a
c
c
e
e
Last step allows defining the interface required to export the control result.
INTERFACE PARAMETERS
1 – Wiegand [OFF]
2 – DataClock [OFF]
3 – ID on UDP [OFF]
4 – Next
Each interface can be configured and activated independently.
Select 4 – Next to go to next step.
Wiegand configuration
Three protocols are available 26, 32 and 34 bits.
For other Wiegand configurations, please refer to chapter
Authentication:
ID input from Wiegand.
WIEGAND
1 – 26 bits [●]
2 – 34 bits [ ]
3 – 32 bits [ ]
4 – OFF [ ]
DataClock configuration
DataClock interface can be activated – but is multiplexed with Wiegand
output.
UDP activation
UDP remote messages can also be activated. The server IP address must
be specified.
SERVER IP ADDRESS
10.10.161.7_
VALID