User's Manual

Safety instructions – Please Read Before Installation

WARNING: Installation must be performed by professional

installers

Note: These instructions for the installation of the

MorphoAccess assume the installer is properly qualied as a

professional, and is familiar with applicable industry standards,

local building/zoning codes, and proper installation practices.

Installation should not be attempted by non-professionals.

You are required to use an NEC class II power supply at

12 V ± 5% and 2.5 A minimum.

This product is intended to be installed in accordance with the

NEC Class 2 requirements; or supplied by a listed external

Power Unit marked Class 2, Limited Power source, or LPS and

rated 12 V DC, 2.5 A minimum.

Europe: SAGEM SA hereby declares that the SAGEM SA

MorphoAccess™ has been tested and found compliant with the

below listed standards as required by the EMC Directive 89/336/

EEC: EN55022 (1994) / EN55024 (1998) and by the low voltage

Directive 73/23/EEC amended by 93/68/EEC: EN60950 (2000).

USA: This equipment has been tested and found compliant

with Class B digital device requirements, pursuant to part 15

of the FCC Rules. These requirements are designed to ensure

reasonable protection against harmful RF interference in a

residential installation. This equipment generates, uses and

can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may interfere with

radio communications. If this equipment interferes with radio or

television reception - which can be determined by disconnecting

and re-connecting the unit - the user is encouraged to try to correct

the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna

- Increase the separation between the equipment and receiver

- Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected

- Consult the dealer or an experienced radio/TV technician for

help

Safety instructions