User's Manual

Stage 2: Mounting the metal chassis assembly

Chassis bold receivers

1) Disconnect the ribbon cable between the motherboard and the

terminal block board so that the assembly shown above can

be detached from the rest of MorphoAccess

2) Pass the connecting cables through the cable entry.

3) Position the chassis assembly against the mounting surface

using the two screws in the mounting keyholes.

4) Hold the chassis in place with a screw through the mounting

slot.

5) Adjust the position of the chassis assembly, and x it in place

by tightening all three screws.

6) Connect the cables to the terminal blocks (see the detailed

instructions in the following sections).

Installation procedure-Stage 2