User's Manual

ManualsBrandsSagem Wireless ManualsElectronicsMA110

Table Of Contents

INTRODUCTION
INTERFACES PRESENTATION
- Man-machine interface
- Electrical interfaces
SETTING UP THE TERMINAL IP ADDRESS
ACCESS CONTROL PRESENTATION
- Identification - authentication
  - Identification
  - Authentication
- “Hit or No Hit” result communication
- “Proxy” mode
CONFIGURING A “CONNECTED” MORPHOACCESS
- Introduction
- Network factory settings
CONFIGURING A STANDALONE MORPHOACCESS
- “USB” key administration
- Principle
  - Store a file on a USB Key
  - Apply changes on a “stand alone” MorphoAccess
CHANGING A PARAMETER
- Configuration interface
- Configuration organization
- “Configuration tool”
UPGRADING THE FIRMWARE
ACCESS CONTROL BY IDENTIFICATION
ACCESS CONTROL BY AUTHENTICATION (MA120 / MA110 ONLY)
- Contactless authentication with templates on card:
  - Contactless authentication with templates on local database:
  - Contactless authentication based on card mode:
- Contactless authentication with templates on a contactless c
  - Required tags on card
- Contactless authentication with templates on local database
  - Required tags on card
- Contactless authentication based on card mode
  - Required tags on card
- Bypassing the biometric control in authentication
  - Required tags on card
- Merged mode
- MorphoAccess 220 320 compatibility
PROXY MODE
RECOGNITION MODE SYNTHESIS
SETTING UP RECOGNITION MODE
- Two attempts mode
- Parameters
SETTING UP MATCHING PARAMETERS
RELAY ACTIVATION
LED IN ACTIVATION
LOG FILE
REMOTE MESSAGES
- Presentation
- Supported Protocols
TAMPER SWITCH MANAGEMENT
- Alarm activation
- Examples
  - Example 1: Send an alarm ID (62221) in Wiegand, and play sou
  - Example 2: Send an alarm in UDP quietly in case of intrusion
MAN MACHINE INTERFACE
- Convention
- Identification – waiting for a finger
- Authentication – waiting for a badge
- Fusion - waiting for a finger or a badge
- Control OK
- Control failed
- No database or empty database
- Biometric acquisition, bad placement
- USB key can be removed
- Sensor failed
NETWORK PARAMETERS
- Section [boot proto]
  - DHCP activated
- Section [parameters]
TERMINAL INFORMATION
- Section [info] (read only)
ADMINISTRATION PARAMETERS
- Section [remote management TCP]
  - Inactivity timeout
  - Port
- Section [terminal]
  - Group
ANNEX: CONTACTLESS MODES TABLE
ANNEX: REQUIRED TAGS ON CONTACTLESS CARD
FAQ
- Terminal IP address is unknown or terminal is not reachable
- Sensor is off
- Terminal returns erratic answers to ping requests
BIBLIOGRAPHY

Siège social : Le Ponant de Paris

27, rue Leblanc - 75512 PARIS CEDEX 15 - FRANCE