User's Manual
Table Of Contents
- INTRODUCTION
- INTERFACES PRESENTATION
- SETTING UP THE TERMINAL IP ADDRESS
- ACCESS CONTROL PRESENTATION
- CONFIGURING A “CONNECTED” MORPHOACCESS
- CONFIGURING A STANDALONE MORPHOACCESS
- CHANGING A PARAMETER
- UPGRADING THE FIRMWARE
- ACCESS CONTROL BY IDENTIFICATION
- ACCESS CONTROL BY AUTHENTICATION (MA120 / MA110 ONLY)
- Contactless authentication with templates on card:
- Contactless authentication with templates on a contactless c
- Contactless authentication with templates on local database
- Contactless authentication based on card mode
- Bypassing the biometric control in authentication
- Merged mode
- MorphoAccess 220 320 compatibility
- PROXY MODE
- RECOGNITION MODE SYNTHESIS
- SETTING UP RECOGNITION MODE
- SETTING UP MATCHING PARAMETERS
- RELAY ACTIVATION
- LED IN ACTIVATION
- LOG FILE
- REMOTE MESSAGES
- TAMPER SWITCH MANAGEMENT
- MAN MACHINE INTERFACE
- NETWORK PARAMETERS
- TERMINAL INFORMATION
- ADMINISTRATION PARAMETERS
- ANNEX: CONTACTLESS MODES TABLE
- ANNEX: REQUIRED TAGS ON CONTACTLESS CARD
- FAQ
- BIBLIOGRAPHY
T
T
E
E
R
R
M
M
I
I
N
N
A
A
L
L
I
I
N
N
F
F
O
O
R
R
M
M
A
A
T
T
I
I
O
O
N
N
These parameters can be changed using the Configuration Tool or by
implementing ILV commands.
The “app.cfg” file contains information about your terminal configuration.
S
S
e
e
c
c
t
t
i
i
o
o
n
n
[
[
i
i
n
n
f
f
o
o
]
]
(
(
r
r
e
e
a
a
d
d
o
o
n
n
l
l
y
y
)
)
Type
120: MorphoAccess™ with local database and Mifare
TM
contactless reader
110: MorphoAccess™ with local database and ICLASS
TM
contactless
reader
100: MorphoAccess™ with local database.
Minor
Software revision (minor)
Major
Software revision (major)
Release
Release version.
SAGEM Défense Sécurité document. Reproduction and disclosure forbidden 43