User's Manual
Table Of Contents
- INTRODUCTION
- INTERFACES PRESENTATION
- SETTING UP THE TERMINAL IP ADDRESS
- ACCESS CONTROL PRESENTATION
- CONFIGURING A “CONNECTED” MORPHOACCESS
- CONFIGURING A STANDALONE MORPHOACCESS
- CHANGING A PARAMETER
- UPGRADING THE FIRMWARE
- ACCESS CONTROL BY IDENTIFICATION
- ACCESS CONTROL BY AUTHENTICATION (MA120 / MA110 ONLY)
- Contactless authentication with templates on card:
- Contactless authentication with templates on a contactless c
- Contactless authentication with templates on local database
- Contactless authentication based on card mode
- Bypassing the biometric control in authentication
- Merged mode
- MorphoAccess 220 320 compatibility
- PROXY MODE
- RECOGNITION MODE SYNTHESIS
- SETTING UP RECOGNITION MODE
- SETTING UP MATCHING PARAMETERS
- RELAY ACTIVATION
- LED IN ACTIVATION
- LOG FILE
- REMOTE MESSAGES
- TAMPER SWITCH MANAGEMENT
- MAN MACHINE INTERFACE
- NETWORK PARAMETERS
- TERMINAL INFORMATION
- ADMINISTRATION PARAMETERS
- ANNEX: CONTACTLESS MODES TABLE
- ANNEX: REQUIRED TAGS ON CONTACTLESS CARD
- FAQ
- BIBLIOGRAPHY
R
R
E
E
L
L
A
A
Y
Y
A
A
C
C
T
T
I
I
V
V
A
A
T
T
I
I
O
O
N
N
If the control is successful, a relay may be activated to directly control a
door. This installation type offers a low security level.
Relay activation
app/relay/enabled
1
The relay aperture time can be defined and is set by default to 3 seconds
(i.e. 300).
Relay aperture time in 10 ms
app/relay/aperture time in 10 ms
300
( 50 to 60000 )
SAGEM Défense Sécurité document. Reproduction and disclosure forbidden 33