User's Manual
Table Of Contents
- INTRODUCTION
- INTERFACES PRESENTATION
- SETTING UP THE TERMINAL IP ADDRESS
- ACCESS CONTROL PRESENTATION
- CONFIGURING A “CONNECTED” MORPHOACCESS
- CONFIGURING A STANDALONE MORPHOACCESS
- CHANGING A PARAMETER
- UPGRADING THE FIRMWARE
- ACCESS CONTROL BY IDENTIFICATION
- ACCESS CONTROL BY AUTHENTICATION (MA120 / MA110 ONLY)
- Contactless authentication with templates on card:
- Contactless authentication with templates on a contactless c
- Contactless authentication with templates on local database
- Contactless authentication based on card mode
- Bypassing the biometric control in authentication
- Merged mode
- MorphoAccess 220 320 compatibility
- PROXY MODE
- RECOGNITION MODE SYNTHESIS
- SETTING UP RECOGNITION MODE
- SETTING UP MATCHING PARAMETERS
- RELAY ACTIVATION
- LED IN ACTIVATION
- LOG FILE
- REMOTE MESSAGES
- TAMPER SWITCH MANAGEMENT
- MAN MACHINE INTERFACE
- NETWORK PARAMETERS
- TERMINAL INFORMATION
- ADMINISTRATION PARAMETERS
- ANNEX: CONTACTLESS MODES TABLE
- ANNEX: REQUIRED TAGS ON CONTACTLESS CARD
- FAQ
- BIBLIOGRAPHY
M
M
e
e
r
r
g
g
e
e
d
d
m
m
o
o
d
d
e
e
This mode is the fusion of identification mode and contactless
authentication without database mode.
So this mode allows:
Running an identification if user places his finger (operation identical to
identification mode),
Running a contactless authentication if user places his contactless card
(operation identical to contactless authentication without database
mode).
If there is no database contactless card presentation is still possible.
This mode is activated by enabling one contactless mode and
identification.
Merged mode
app/bio ctrl/identification
1
And
app/bio ctrl/authent PK contactless
app/bio ctrl/authent card mode
0 or 1
0 or 1
Required tag on card depends on the authentication mode.
SAGEM Défense Sécurité document. Reproduction and disclosure forbidden 27