User's Manual
Table Of Contents
- INTRODUCTION
- INTERFACES PRESENTATION
- SETTING UP THE TERMINAL IP ADDRESS
- ACCESS CONTROL PRESENTATION
- CONFIGURING A “CONNECTED” MORPHOACCESS
- CONFIGURING A STANDALONE MORPHOACCESS
- CHANGING A PARAMETER
- UPGRADING THE FIRMWARE
- ACCESS CONTROL BY IDENTIFICATION
- ACCESS CONTROL BY AUTHENTICATION (MA120 / MA110 ONLY)
- Contactless authentication with templates on card:
- Contactless authentication with templates on a contactless c
- Contactless authentication with templates on local database
- Contactless authentication based on card mode
- Bypassing the biometric control in authentication
- Merged mode
- MorphoAccess 220 320 compatibility
- PROXY MODE
- RECOGNITION MODE SYNTHESIS
- SETTING UP RECOGNITION MODE
- SETTING UP MATCHING PARAMETERS
- RELAY ACTIVATION
- LED IN ACTIVATION
- LOG FILE
- REMOTE MESSAGES
- TAMPER SWITCH MANAGEMENT
- MAN MACHINE INTERFACE
- NETWORK PARAMETERS
- TERMINAL INFORMATION
- ADMINISTRATION PARAMETERS
- ANNEX: CONTACTLESS MODES TABLE
- ANNEX: REQUIRED TAGS ON CONTACTLESS CARD
- FAQ
- BIBLIOGRAPHY
U
U
P
P
G
G
R
R
A
A
D
D
I
I
N
N
G
G
T
T
H
H
E
E
F
F
I
I
R
R
M
M
W
W
A
A
R
R
E
E
It is possible to upgrade your MorphoAccess™ firmware. Two packages
type are available. One dedicated to terminal system, another one
dedicated to biometric library.
Use the MA1XX Downloader to upgrade your terminal system.
Use the MA1XX BioLoader to upgrade your terminal biometric library.
Please refer to the MA100 Series Upgrade Tools User Guide for more
information about upgrade procedures.
20 SAGEM Défense Sécurité document. Reproduction and disclosure forbidden