User's Manual
Table Of Contents
- INTRODUCTION
- INTERFACES PRESENTATION
- SETTING UP THE TERMINAL IP ADDRESS
- ACCESS CONTROL PRESENTATION
- CONFIGURING A “CONNECTED” MORPHOACCESS
- CONFIGURING A STANDALONE MORPHOACCESS
- CHANGING A PARAMETER
- UPGRADING THE FIRMWARE
- ACCESS CONTROL BY IDENTIFICATION
- ACCESS CONTROL BY AUTHENTICATION (MA120 / MA110 ONLY)
- Contactless authentication with templates on card:
- Contactless authentication with templates on a contactless c
- Contactless authentication with templates on local database
- Contactless authentication based on card mode
- Bypassing the biometric control in authentication
- Merged mode
- MorphoAccess 220 320 compatibility
- PROXY MODE
- RECOGNITION MODE SYNTHESIS
- SETTING UP RECOGNITION MODE
- SETTING UP MATCHING PARAMETERS
- RELAY ACTIVATION
- LED IN ACTIVATION
- LOG FILE
- REMOTE MESSAGES
- TAMPER SWITCH MANAGEMENT
- MAN MACHINE INTERFACE
- NETWORK PARAMETERS
- TERMINAL INFORMATION
- ADMINISTRATION PARAMETERS
- ANNEX: CONTACTLESS MODES TABLE
- ANNEX: REQUIRED TAGS ON CONTACTLESS CARD
- FAQ
- BIBLIOGRAPHY
“
“
C
C
o
o
n
n
f
f
i
i
g
g
u
u
r
r
a
a
t
t
i
i
o
o
n
n
t
t
o
o
o
o
l
l
”
”
The Configuration Tool allows changing these parameters. This program
is an illustration of utilization of the TCP API. Please refer to Configuration
Tool User Guide for more information about this program.
SAGEM Défense Sécurité document. Reproduction and disclosure forbidden 19