User's Manual

ManualsBrandsSagem Wireless ManualsElectronicsMA110

Table Of Contents

INTRODUCTION
INTERFACES PRESENTATION
- Man-machine interface
- Electrical interfaces
SETTING UP THE TERMINAL IP ADDRESS
ACCESS CONTROL PRESENTATION
- Identification - authentication
  - Identification
  - Authentication
- “Hit or No Hit” result communication
- “Proxy” mode
CONFIGURING A “CONNECTED” MORPHOACCESS
- Introduction
- Network factory settings
CONFIGURING A STANDALONE MORPHOACCESS
- “USB” key administration
- Principle
  - Store a file on a USB Key
  - Apply changes on a “stand alone” MorphoAccess
CHANGING A PARAMETER
- Configuration interface
- Configuration organization
- “Configuration tool”
UPGRADING THE FIRMWARE
ACCESS CONTROL BY IDENTIFICATION
ACCESS CONTROL BY AUTHENTICATION (MA120 / MA110 ONLY)
- Contactless authentication with templates on card:
  - Contactless authentication with templates on local database:
  - Contactless authentication based on card mode:
- Contactless authentication with templates on a contactless c
  - Required tags on card
- Contactless authentication with templates on local database
  - Required tags on card
- Contactless authentication based on card mode
  - Required tags on card
- Bypassing the biometric control in authentication
  - Required tags on card
- Merged mode
- MorphoAccess 220 320 compatibility
PROXY MODE
RECOGNITION MODE SYNTHESIS
SETTING UP RECOGNITION MODE
- Two attempts mode
- Parameters
SETTING UP MATCHING PARAMETERS
RELAY ACTIVATION
LED IN ACTIVATION
LOG FILE
REMOTE MESSAGES
- Presentation
- Supported Protocols
TAMPER SWITCH MANAGEMENT
- Alarm activation
- Examples
  - Example 1: Send an alarm ID (62221) in Wiegand, and play sou
  - Example 2: Send an alarm in UDP quietly in case of intrusion
MAN MACHINE INTERFACE
- Convention
- Identification – waiting for a finger
- Authentication – waiting for a badge
- Fusion - waiting for a finger or a badge
- Control OK
- Control failed
- No database or empty database
- Biometric acquisition, bad placement
- USB key can be removed
- Sensor failed
NETWORK PARAMETERS
- Section [boot proto]
  - DHCP activated
- Section [parameters]
TERMINAL INFORMATION
- Section [info] (read only)
ADMINISTRATION PARAMETERS
- Section [remote management TCP]
  - Inactivity timeout
  - Port
- Section [terminal]
  - Group
ANNEX: CONTACTLESS MODES TABLE
ANNEX: REQUIRED TAGS ON CONTACTLESS CARD
FAQ
- Terminal IP address is unknown or terminal is not reachable
- Sensor is off
- Terminal returns erratic answers to ping requests
BIBLIOGRAPHY

This feature is available to change network parameters (IP address, mask

and gateway).

Store a file on a USB Key

The administrator creates a configuration file on a PC using the USB

Network Configuration Tool. This configuration file contains new network

parameters. This file must be stored on a USB Mass Storage Key.

Configuration File:

network parameters

Apply changes on a “stand alone” MorphoAccess

The lower protection of the MorphoAccess must be removed to give

access to the USB Host Interface of the terminal. The terminal must be

powered on.

When the USB key is inserted in the MorphoAccess USB interface, the

configuration file is read: Ethernet parameters are applied.

Configuration File:

network parameters

At the end of the process a low-pitched “beep” indicates that the key can

be removed.

Please refer to USB Network Configuration Tool User Guide for more

information about this procedure.

SAGEM Défense Sécurité document. Reproduction and disclosure forbidden 17