User's Manual

Activating your phone 15
Charging the battery
Your phone is powered by a rechargeable
battery. A new battery must be charged for at
least 4 hours before being used for the first time.
It reaches its optimum capacity after a few
cycles of use.
When your battery has been discharged, the
phone displays the state (empty battery icon
flashes). In this case recharge your battery for at
least 15 minutes before making any more calls
so as to avoid being cut off mid-call.
To recharge the battery
Connect the charger to a mains socket. Plug the end of the cable into
the connector at the base of the phone. The phone starts to charge
up. Charging stops by itself. Disconnect the cable.
It is possible that the battery may heat up slightly during charging;
this phenomenon is normal.
WARNING - There is danger of explosion if the battery is placed in an
incorrectly way or if it is exposed to fire.
Do not short circuit it.
The battery does not have any part that you can change.
Do not try to open the battery casing.
Use only the appropriate chargers and batteries as shown in the phone
manufacturer's catalogue.
The use of other types of chargers or batteries may be dangerous or
invalidate the warranty.
Used batteries must be disposed of in the appropriate places.
We advise you to take the battery out if you plan not to use the phone for
extended periods.
You are strongly advised not to connect your phone to the charger if it
doesn’t contain a battery.
The charger is a safety step-down transformer, it is forbidden to modify,
alter or replace it by another component (power supply plug, etc).
If the battery has entirely discharged, the phone cannot start. Plug the
phone to the charger. The phone will switch on after a few minutes of
charge. You can use the phone again when the Start option is displayed on
the screen.
252725318_my200L-201L-202L_TWIN_lu_en.book Page 15 Vendredi, 26. mai 2006 9:30 09