User's Manual
Table Of Contents
- Conformance Document
- FCC Conformance Document
- Safety Information for Wireless handled phones
- Functions at a glance
- Menus at a glance
- Glossary
- Presentation of the phone
- Getting started
- Initial communication - Hands-free mode
- Directory
- Messages
- Calls
- Ringing tones
- Settings
- Security
- Accessories
- WAP (depending on model)
- Games
- Available accessories
- Technical Characteristics
- Care and safety information
- SAR at the ear (W/kg)
- SAR worn of the body (W/kg)
- Version
- FCC ID
- GSM 850
- PCS 1900
- GSM 850
- PCS 1900
- Problem - Situation
- Actions
- Customer care
24
Getting started
Your phone is powered by a rechargeable battery. A new battery must be
charged for at least 4 hours before it is used for the first time. It will reach its
nominal capacity after several usage cycles.
When your battery has run down, the phone displays it and cuts out.
To recharge your battery:
- Connect the charger to a wall outlet.
- Connect the end of the charging cable to the bottom of your phone.
- The phone will start charging. The battery charging indicator indicates the
charge.
- Charging stops by itself.
- Unplug the cable.
It is possible that during charging, the battery may heat up slightly; this is
normal.
Charging the battery
4
1
g
h
i
2
3
6
m
n
o
9
5
jk
l
tu
v
+
7
p
q
r
s
a
b
c
d
e
f
w
x
y
z
8
0
Warning
There is a risk of explosion if the battery is incorrectly replaced or disposed of in fire.
Do not short-circuit.
The battery does not contain any components that can be changed by you.
Do not attempt to open the battery case.
Only use the correct chargers and batteries as shown in the manufacturer’s catalogue.
Spent batteries must be collected at the appropriate sites.
You are advised to remove the battery if you intend to leave your phone unused for a long period.
251873962_myX-1a Twin_lu_en.book Page 24 Vendredi, 7. janvier 2005 3:00 15