Instruction Manual


Réf. : SCT TMO MASV3 SPEC
30
Rev. : H
Réf. sec. : 2x xxx xxx – x
Date : 12/05/04
DRAFT
Document

. All rights of reproduction and disclosure reserved.
Page 8
This document contains information on a product under development. SAGEM reserves the right to change or discontinue this product
without notice.
Keyboard / LCD backlight / network LED (GB)
GB LED management. Interface to external backlight
and RGB component.
Audio up-link
2x2 differential inputs are provided for microphone
(accessories and handset).
Audio down-link non stereo
3x2 differential outputs are provided for non stereo
earphone (accessories and 6 ohms and 32 ohms).
Audio down-link stereo
3 outputs are provided for stereo earphone
(accessories and handset).
Flap open/closed detection
IO5 dedicated for Flap.
Keyboard interface
6x6 keyboard interface is provided on ball-out.
UART1 interface with flow control
Up to 115.2 Kbaud with auto bauding.
Full flow control signals (+2.8V) are provided on ball-
out.
If a full compliant RS232 (+/-5V) serial interface is
needed
:
The drivers (like MAX3232, ST3237CD, …) are not
included in the module and have to be added on the
main PCB.
A proven schematic to build the RS232 interface is
provided in application note.
IrDA interface or UART2 interface
Up to 115.2 Kbaud.
UART2 and IrDA are not multiplexed but could not be
used at the same time.
Data services
GPRS, CSD, Fax
Supplementary services
Line identification, Call Waiting, Call Hold, Call
Forwarding, Multiparty, Closed User Group, Call
Barring, Advice of Charge, USSD
USB interface
USB 1.1 (slave only) is provided on ball-out.
Melody chip interface
The melody chip is not integrated in the module but
the interface is provided (power supply, clock, analog
audio, serial link, I2S) on ball-out.
Serial Interface
A serial interface is provided on ball-out in order to
manage an external LCD or a chip melody.
Companion chip Interface
A parallel interface (16 bits) is provided on ball-out (3
addresses, 1 chip select, OE and RW signals are
available) to connect external companion chip for
additional multimedia application.
LCD parallel interface
A parallel interface (8bits) is provided on ball-out (2
chip select, RW, RS, ESTRB, RESET) to connect
LCDs up to 256K colours.
MMC interface for SD card only
MMC interface is available on ball-out (power supply
not provided) for SD card only.
Video sensor interface
Video sensor interface is provided on ball-out
(parallel interface with 8 bit, clock in, clock out,
horizontal synchronisation, vertical synchronisation,
reset, standby, I2C interface) to connect VGA sensor
(power supply not provided).
Blue tooth interface (optional)
Blue tooth chipset not included in the module but the
interface (MCSI, Clock 26MHz and UART) is
available on ball-out. Blue tooth chipset management
is optional.
Reset pin
Active high signal available (reset of all the system
including backup).
Power on pin
Available