User Manual

13
EN
Troubleshooting
PROBLEM POSSIBLE CAUSE
Tea Maker
™
will
not switch ‘ON’
•
Check the power plug is securely inserted into the outlet.
•
Insert the power plug into an independent outlet.
•
Insert the power plug into a dierent outlet.
•
Reset the circuit breaker if necessary.
•
For additional safety the Tea Maker
™
is tted with a thermal cut out.
In the event of severe overheating, the Tea Maker
™
will automatically
shut down to prevent further damage. Should this continue,
visit Sage Customer Service at sageappliances.com.
The Tea Maker
™
will not work
•
Check the glass jug is securely positioned on the power base.
The LCD light has
gone out?
•
The Tea Maker
™
goes into standby mode if not used for 3 minutes.
•
To re-activate the Tea Maker
™
out of standby mode:
- Remove then replace the glass jug from the power base.
- Press any button on the power base except the HOT WATER / Cancel
or TEA / Cancel buttons. The LCD screen will re-illuminate.
I cannot select a
certain function
•
Certain features cannot be selected or changed during the heating
or brewing cycle. The LCD screen may temporarily change or a sound
alert may be heard, but no changes to the cycle will be made.
The LCD screen
displays ‘RESET’
•
The LCD screen will display a ashing ‘RESET’ when there is a resettable
electronic issue. Remove the plug from the wall outlet, wait 5 seconds,
then plug back in.
•
Visit Sage Customer Service at sageappliances.com if the ‘RESET’
message continues.
The LCD screen
displays ‘ERROR’
•
The LCD screen will display a ashing ‘ERROR’ when there
is a non-resettable issue with the appliance. Should this occur,
visit the Sage Customer Service at sageappliances.com