CREATISTA UNO MY MACHINE
EN User manual 1 3
EN •• Nespresso Sage Creatista Uno Congratulations on your purchase of the Nespresso Sage Creatista Uno, the machine that allows you to make cafe quality milk coffees.
EN Packaging Content Creatista Uno USER MANUAL ❶ Creatista Uno Coffee Machine ❷ Tasting Box of Nespresso Capsules Nespresso is an exclusive system creating the perfect Espresso, time after time. Each parameter has been calculated with great precision to ensure that all the aromas from each capsule can be extracted, to give the coffee body and create an exceptionally thick and smooth crema. CAUTION: When you see this sign, please refer to the important safeguards to avoid possible harm and damage.
Content EN Nespresso Creatista Uno 2 Packaging Content 3 Creatista Uno 3 Specifications Safety Precautions Machine Overview First Use Regular Coffee Preparation 3 5-7 8 9-10 11 Milk Coffee Preparation 12-13 Latte Macchiato Preparation 14-15 Adjusting Regular Coffee Drinks 16 Reset to Factory Settings 16 Emptying the System 17 Energy Saving 18 Daily Cleaning 18-19 Steam Wand Cleaning Descaling 20 21-22 Water Hardness 23 Troubleshooting 24 Troubleshooting Milk Froth Preparation
EN Safety Precautions CAUTION ELECTRICAL DANGER CAUTION: the safety precautions are part of the appliance. Read them carefully before using your new appliance for the first time. Keep them in a place where you can find and refer to them later on. CAUTION: when you see this sign, please refer to the safety precautions to avoid possible harm and damage. INFORMATION: when you see this sign, please take note of the advice for the correct and safe usage of your appliance.
Safety Precautions •• from the power socket. Only plug the appliance into suitable, easily accessible, earthed mains connections. Make sure that the voltage of the power source is the same as that specified on the rating plate. The use of an incorrect connection voids the warranty. The appliance must only be connected after installation. Do not pull the cord over sharp edges, clamp it or allow it to hang down. •• Keep the cord away from heat and damp.
EN Safety Precautions Do not put fingers into capsule compartment or the capsule shaft. Danger of injury! •• Water could flow around a capsule when not perforated by the blades and damage the appliance. •• Never use a damaged or deformed capsule. If a capsule is blocked in the capsule compartment, turn the machine off and unplug it before any operation. Call the Nespresso Club or Nespresso authorised representative. •• Fill the water tank only with fresh and potable water.
Machine Overview EN EN Control panel Water tank & lid Lever for capsule insertion Capsule container Removable pin cleaning tool Pop out cup support Removable drip grid Removable drip tray with full indicator Control Panel Descale alert LED Lungo button Easy clean steam wand Espresso button Ristretto button Milk jug temperature sensor Steam wand clean alert LED Milk temperature button Milk froth level button Steam button Milk jug 8
EN First Use Read the important safeguards first to avoid risks of fatal electrical shock and fire. 1 4 Plug the machine into the power outlet. 2 Rinse the water tank before filling it with potable water. 5 3 Fill the water tank with potable water. Turn the machine ON by pressing the Lungo, Espresso, Ristretto, or Steam button. The buttons will flash while the machine heats up. Heating up takes approximately 3 seconds. The Lungo button will illuminate once heated.
First Use EN 7 < 1 minute Setting your water hardness, dip the Water Hardness Test Strip in and out of the water tank. Wait 1 minute. Press and hold the temperature button and the milk froth level button for 5 seconds to set the water hardness level. Pressing temperature button increases the level and pressing milk froth button decreases the level. Set the water hardness according to the results on the Test Strip. For further information refer to page 23. Press any button not blinking to save and exit.
EN Regular Coffee Preparation 1 Fill the water tank with potable water. 4 Lift the Lever, insert a capsule and close the lever. Press one of the coffee buttons to extract. Ristretto (25 ml / 0.85 fl.oz) Espresso (40 ml / 1.35 fl.oz) Lungo (110 ml / 3.7 fl.oz) T o ensure hygienic conditions, it is highly recommended to not reuse a used capsule. 11 2 3 Turn the machine ON by pressing Ristretto, Espresso, Lungo, or Steam button. The buttons will flash while the machine heats up.
Milk Coffee Preparation Only use the milk jug provided. 1 Fill the water tank with fresh potable water. EN TIP: This machine is optimised for pasteurised whole or semi skimmed milk, refrigerated & freshly opened. Milk Temperature and Milk Froth may be adjusted to suit different milk types. 2 3 To accommodate smaller cups, use the cup support. PUSH the cup support to unlock. MAX MIN Fill the milk jug with enough fresh cold milk from the fridge.
EN Milk Coffee Preparation 7 Press one of the coffee buttons to start the coffee extraction. 8 3 2 1 3 2 1 10 13 When milk frothing is complete, lift the steam wand, remove the jug and wipe with a clean damp cloth. 9 When the coffee extraction is complete, select milk setting for your preferred drink. Start milk frothing by pressing steam button.
Latte Macchiato Preparation 1 Fill the water tank with fresh potable water. EN 2 3 To accommodate a Latte Macchiato glass, push the cup support in until it locks. MAX Fill the milk jug to the marked maximum level with fresh cold milk from the fridge. CAUTION: Do not fill milk jug above the maximum level marked on the inside & outside of the jug. MIN 4 3 2 1 Set milk froth level at 3 and temperature level at 2.
EN Latte Macchiato Preparation 7 When milk frothing is 8 Allow steam wand to return to completed, lift the steam wand, wipe with a clean damp cloth. 9 Pour milk into the Latte its down position & it will auto purge to rinse itself. Macchiato glass. Rinse the jug. CAUTION: Jug surface gets hot. Use the handle to lift the jug. 10 15 Place the Latte Macchiato glass under the coffee spout. 11 Lift the Lever & insert your capsule. And close the lever.
Adjusting Regular Coffee Drinks 1 Lift the Lever & insert your capsule. Press and hold one coffee button you want to adjust among Ristretto, Espresso, and Lungo. 2 EN Release the button after desirable shot duration. 3 Adjusted coffee volume will be saved for next use. Any coffee can be programmed 1. Ristretto: 15-30ml / 0.5-1oz 2. Espresso: 30-70ml / 1-2.3oz 3. Lungo: 70-130ml / 2.3-4.4oz Default coffee volumes listed on page 11. Reset to Factory Settings 1 To reset factory settings: 1.
EN Emptying the System before a period of non-use or for frost protection 1 4 17 2 Turn off the machine by pressing and holding Ristretto button and Steam button together for 0.5 seconds. Press the Espresso button or the Lungo button to start emptying cycle. Press any button not blinking to exit the mode. 5 Remove the water tank. Place the empty Milk Jug under the coffee outlet. When the pump stops, empty & wipe dry the capsule bucket & drip tray.
Energy Saving Daily Cleaning EN To ensure hygienic conditions, it is highly recommended emptying and cleaning the capsule container every day. 1 1 Energy efficient: Machine minimises power use when not making a drink. After 10 mins of no use, the machine enters sleep mode. Restart by pressing Ristretto, Espresso, Lungo, or Steam button. Empty the drip tray and the capsule container every day.
EN Daily Cleaning 4 19 Do not use any strong or abrasive solvent, sponge or cream cleaner. Do not put the parts in the dishwasher. Only the milk jug is dishwasher safe. 5 Dry all the parts with a soft clean cloth and reassemble all parts. Clean the coffee outlet and inside the machine regularly with a clean damp cloth. 6 Never immerse the appliance or part of it in water or any other liquid.
Steam Wand Cleaning EN It is recommended that you perform this monthly to prevent steam tip blockages or when the steam wand clean alert LED is on. When it flashes, do manual steaming by pressing and holding the Steam button for 3 seconds. 1 4 2 Remove the pin cleaning tool located in the back of the machine, under the water tank. Use the pin cleaning tool to remove the steam tip cap. 5 3 Unscrew and remove the steam tip.
EN Descaling Duration approximately 15 minutes Read the important safeguard on the descaling package and refer to the table for the frequency of use.The descaling solution can be harmful. Avoid contact with eyes, skin and surfaces. Never use any product other than the Nespresso descaling kit available at the Nespresso Club to avoid damage to your machine. The following table will indicate the descaling frequency required for the optimum performance of your machine, based on water hardness.
Descaling EN 4 Make sure the machine is off. Press and hold the Ristretto button and the Steam button together for 5 seconds to enter the descaling mode. The Ristretto and the Steam buttons will be solid on. Press any button not illuminated to exit the mode. Press the Ristretto button or the Steam button to start the descaling process. Both buttons will blink. 5 Descaling Milk froth level LED will indicate the progress of the descaling process. 6 7 Once finished, discard liquid from the container.
EN Water Hardness 1 2 Turn the machine ON by pressing the Lungo, Espresso, Ristretto, or Steam button. Heating up takes approximately 3 seconds. Setting your water hardness, dip the Water Hardness Test Strip in and out the water tank. Wait 1 minute. Press and hold the temperature button and the milk froth button for 5 seconds to set the water hardness level. Pressing temperature button increases the level and pressing milk froth button decreases the level.
Troubleshooting Buttons not illuminated EN - Check the water tank. If empty, fill with portable water. - Machine turns OFF automatically. See paragraph on «Energy Saving Concept». - Press the Ristretto, Espresso, or Lungo button to turn to «ON-mode». - Press the Ristretto, Espresso, or Lungo button to turn to «ON-mode». - Check the descale alert LED or the steam wand cleaning alert LED is on. If on, descale or clean the steam wand.
EN 25 Troubleshooting Milk Froth Preparation Milk steam cycle does not start - Check if the water tank is correctly positioned, if empty, fill with potable water. - Check steam tip for any blockages and ensure wand is lowered. Quality of froth not up to standard - Be sure to use pasteurised whole or semi-skimmed milk at refrigerated temperature (about 4-6 °C / 39-43 °F). For a better result, the milk must be newly opened. - Check the milk froth setting.
Contact the Nespresso Club EN As we may not have foreseen all uses of your appliance, should you need any additional information, in case of problems or simply to seek advice, call the Nespresso Club or your Nespresso authorised representative. Contact details for your Nespresso Club or your Nespresso authorised representative can be found in the «Welcome to Nespresso» folder in your machine box or at nespresso.
EN Limited Guarantee During the design and engineering of this product, quality was at the forefront of each material and component choice we made, which is why we proudly stand by it with our 2 year warranty and is valid in the UK and Ireland. To validate the purchase date and take advantage of this warranty, you must present your proof of purchase.
Notes EN 28
EN 29 Notes
Notes EN 30
by Nespresso D18 CREATISTA UNO
