Instruction Manual

12
Troubleshooting
PROBLEM EASY SOLUTION
There is no power to
the juicer
• Check if the power cord is properly plugged in.
• Check if the drum lid and the juicing bowl are properly assembled.
• Check if the top-set and the body are properly assembled.
NOTE: Juicer will not operate if parts are not assembled properly.
Low juice yield
• Dierent ingredients hold dierent amounts of uid that will yield dierent
amounts of juice.
• If the ingredients are not fresh, they may contain reduced amount of uid,
which will yield less juice. Soak ingredients in cold water for about
30 minutes prior to juicing for the best result.
• Check if the compression silicone is rmly inserted.
• If the ingredient itself has low water content, it may help to soak it in water
before juicing.
• If juicing ingredients with small seeds, after a few servings, it may reduce
the juice yield. For best result, disassemble and wash the top set in
between juicing.
• If there is seed residue on the bottom of the strainer, this can aect juicer
performance and the overall juice yield.
There is too much
pulp in the juice
• To reduce the ne pulp, clean the top-set frequently and extract the pulp.
• Use a mesh strainer and put the juice through it to collect the
unwanted pulp.
• If the strainer and the screw are damaged and aecting the juicer’s
performance, it is recommended the parts be replaced.
• The lifetime of each part may vary depending on length and method of use
and ingredients extracted.
The drum lid will not
close
• Make sure the juicing screw is pushed all the way in to the strainer in order
for the drum lid to close properly.
• If the juicing screw is not properly in position, the drum lid may not close.