the Big Squeeze™ SJS700
Contents 2 5 6 9 10 12 Important Safeguards Components Assembly Operation Care & Cleaning Troubleshooting SAGE® RECOMMENDS SAFETY FIRST At Sage® we are very safety conscious. We design and manufacture consumer products with the safety of you, our valued customer, foremost in mind. In addition we ask that you exercise a degree of care when using any electrical appliance and adhere to the following precautions.
• Always turn the appliance to the off position, switch off at the power outlet and unplug at the power outlet when the appliance is not in use. • Do not use the appliance if the power cord, plug, or appliance becomes damaged in any way. If damaged and maintenance other than cleaning is required please contact Sage Customer Service or go to sageappliances.com • Any maintenance other than cleaning should be performed by an authorised Sage® service centre • Children should not play with the appliance.
• This appliance shall not be used by children. • Do not leave the appliance unattended when in use. • Do not push food into the feed chute with your fingers or other utensils. Always use the food pusher provided. Do not place hand or fingers into the food chute when it is attached to the appliance. • Do not juice stone fruit unless seeds and/or stones have been removed. • Do not operate the juice extractor without the pulp and juice container in place.
Components A Feeding Feeding Basket Tube D Detachable E B F C G H A. Feeding Tube & Basket For different sizes of produce. B. Juicing Bowl C. Pulp Cup D. Drum Lid I J K L E. Detachable Smart Cap I. Strainer G. Motor Body K. Pusher F. Juice Jug H. Rotation Wiper J. Juicing Screw L.
Assembly BEFORE FIRST USE Before using your Juicer for the first time, remove any packaging material and promotional labels. Ensure the power is in the OFF position, the juicer is switched off at the power outlet and the power cord is unplugged. Wash bowl and juicing tools in warm soapy water with a soft cloth. Rinse and dry thoroughly. When first using your appliance, you may notice an odour coming from the motor. This is normal and will dissipate with use.
ASSEMBLY 1. Firmly insert the compression silicone into the slot below the pulp spout. The Juicer may leak if not assembled properly. 4. Place the drum lid on to the juicing bowl aligning the dot on the drum lid with the red dot on the juicing bowl. 2. Assemble the strainer into the rotation wiper then place this assembly in to the juicing bowl ensuring the red dot on the strainer is aligned with the red dot on the juicing bowl.
7. Place the pulp cup under the pulp spout and place the juice cup under the juice spout as shown in the illustration. Detachable 6. Align arrows on drum lid and motor body. NOTE The juicer will not operate if the down arrow on the drum lid is not completely aligned with the CLOSE mark on the body.
Operation HARD VEGETABLES & HIGH FIBRE FOODS (E.G. CARROTS, BEETROOT, & SPINACH) Insert into the feeding tube. USING YOUR JUICER 1. After preparing the ingredients, plug the power cord into a wall outlet. Do not touch the power cord with wet hands. It may cause electrical shock, short-circuit, or fire. 2. Press the FORWARD button to operate. Tough and fibrous ingredients: Cut to 2cm wide and 5cm long. Forward: Pulls down and slowly masticates the ingredients.
Care & Cleaning Extract all the remaining pulp in the juicing bowl before stopping the juicer. For easier clean up, operate the juicer for an additional 30 seconds after the juice is extracted. Then fill the juicing bowl with water and run the juicer before opening the drum lid. When the drum lid is stuck, press the REVERSE – OFF – FORWARD button in this order, switching back and forth 2 to 3 times to dislodge.
6. Under running water, clean the outside of the juicing screw with a dish scrub. Use the tip of the cleaning brush to push out any residue in the crevices on the bottom of the juicing screw. Thoroughly clean the juicing screw ensuring that the juicing screw is clean without any residue. Thoroughly dry the bottom of the juicing screw. After juicing ingredients with seeds, make sure to thoroughly clean the bottom crevice of the juicing screw.
Troubleshooting PROBLEM EASY SOLUTION There is no power to the juicer • Check if the power cord is properly plugged in. • Check if the drum lid and the juicing bowl are properly assembled. • Check if the top-set and the body are properly assembled. NOTE: Juicer will not operate if parts are not assembled properly. Low juice yield • Different ingredients hold different amounts of fluid that will yield different amounts of juice.
PROBLEM EASY SOLUTION Odd noise from the juicer • Check if the parts are assembled correctly. Try reassembling the parts and listen for the odd noise. • Do not start the juicer unless there are ingredients and/or liquid in it. • Operating the juicer without ingredients can cause damage to the screw. • If the juicer is operated without ingredients or liquid, the noise level can increase and also can lead to damage.
PROBLEM EASY SOLUTION The drum lid is stuck • After juicing, let the juicer operate for another 30 seconds to extract the remaining pulp. • If there is too much pulp in the top-set, this can cause the drum lid to not open. In this situation, press the REVERSE – OFF – FORWARD button in the order, switching back and forth 2 to 3 times. Then place both hands on the drum lid and firmly press down while simultaneously turning the drum lid to open.
Sage® Freephone (UK Landline): 0808 178 1650 Mobile Calls (National Rate): 0333 0142 970 www.sageappliances.co.uk customerservice@sageappliances.co.uk What’s on your mind? Register your product and get more from your purchase Our constant aim is to improve the quality and features of our appliances. We welcome your comments and ideas in assisting our ongoing development. Product registration takes only a few minutes and ensures a record of your purchase.
