User Manual

21
EN
CLEANING THE STEAM WAND
IMPORTANT
After every use, thoroughly wipe the steam wand
and tip with a damp cloth & purge immediately.
Failure to clean the steam wand may aect the
milk texturing performance.
• If any of the holes in the tip of the steam wand
become blocked, ensure the steam lever is in
the centre OFF position and unblock using the
steam tip cleaning tool. Even partially blocked
holes may aect the ability of the steam wand
to produce sucient foam volume.
• If steam wand remains blocked, remove the
tip and soak together with steam wand using
the provided steam wand cleaning powder
(instructions below). Screw tip back onto the
steam wand after rinsing.
• The steam wand can be left immersed
in the milk jug lled with water when not
in use to reduce the risk of blockages.
Steam Wand Cleaning Powder
1. Add 1 packet into an empty milk jug.
2. Add 1 cup (240ml) hot water into milk jug.
3. Remove steam tip and place with steam
wand into jug.
4. Leave to soak for 20 minutes.
5. Clean, rinse and replace steam tip. Place
wand back into the jug and activate steam
for 10 seconds.
6. Allow to soak for 5 minutes.
7. Activate steam several times to purge
the steam wand, then rinse the wand
thoroughly.
8. Wipe the steam wand dry with a
clean cloth.
9. Discard solution & rinse jug thoroughly.
NOTE
If an alternative cleaning solution is used, please
follow the instructions specied. Please ensure
the cleaning solution is food safe and suitable for
stainless steel and silicon products. 
Please ensure the steam wand tip is tightly
fastened after cleaning to avoid temp sensing
error.
CLEANING THE FILTER BASKET
AND PORTAFILTER
• The lter basket and portalter should be
rinsed under hot water after each coee
making session to remove all residual
coee oils.
• If the holes in the lter basket become
blocked, dissolve a cleaning tablet in hot water
and soak lter basket and portalter in solution
for approx. 20 minutes.
Rinse thoroughly.
Steam Wand Tip