User Manual

15
EN
Care & Cleaning
Soak lter
for 5 min
Ensure parts are
connected
Install lter in tank
Install water tankSet current month
1
Replace lter after
90 days or after 40L
!
22 3
54
The provided water lter helps reduce the risk
of scale build-up in and on many of the inner
functioning components. Replacing the water
lter every three months or 40L will reduce the
need to descale the machine.
The limitation of 40L is based on water hardness
level 4. If you are in level 2 area, you can increase
this to 60L.
WARNING
After regular use, hard water can cause mineral
build up in and on many of the inner functioning
components, reducing the brewing ow, brewing
temperature, power of the machine, and taste of
the espresso.
CLEANING CYCLE
The CLEAN ME light will illuminate when a
cleaning cycle is required. This is separate from
descaling.
1. Insert the 1 CUP lter basket into the
portalter, followed by the supplied cleaning
disc, followed by 1 cleaning tablet.
2. Lock the portalter into the group head.
3. Ensure the water tank is lled with cold water
and the drip tray is empty.
4. Press the POWER button to switch the
machine o.
5. Press the 1 CUP and 2 CUP buttons
simultaneously, then also press the POWER
button. Hold all 3 buttons together for
approximately 10 seconds.
6. The cleaning cycle will commence and last
for approximately 5 minutes. During this
time, water will intermittently ush into the
portalter to dissolve the cleaning tablet
and ush back into the group head. If your
cleaning disc is without a hole in the middle,
hardly any or no water should come through
the portalter.
7. Remove the portalter and ensure the tablet
has completely dissolved. If the tablet has
not dissolved; repeat from step 4 of the
cleaning cycle until the tablet is dissolved.
8. Once the tablet has completely dissolved,
remove the cleaning disc, reinsert the
portalter and press the 2 CUP button to
rinse the brew head. We recommend to
place a container under the portalter spout
to avoid water splashing onto the machine.
Once complete, make sure to wipe o any
splashes with a soft dry cloth.
DESCALING
NOTE
Ensure that the water lter is removed from the
water tank before adding the descaling powder
when descaling the machine.
NOTE
The machine will not automatically prompt a
reminder when it is time to run a descaling
cycle. While the cleaning cycle is important for
keeping the brew head clean from coee oils;
the descaling cycle is essential to ensure that
the machine is kept clean on the inside and
free from mineral build-up.It is recommended
REPLACING THE WATER FILTER