User Manual
18
PROBLEM POSSIBLE CAUSE WHAT TO DO
Machine does
not heat up.
STEAM/HOT
WATER light
ashes when
the machine
is turned on.
• STEAM/HOT WATER dial is not in the
STANDBY position.
• Turn the STEAM/HOT WATER dial to the STANDBY
position. Machine will commence heating.
Water does
not ow
from the
group head.
• Machine has not reached operating
temperature.
• Allow time for the machine to reach operating
temperature. The POWER button light will stop
ashing and all button lights on the control panel will
illuminate when ready.
No hot water. • Water tank is empty. • Fill tank.
• Water tank is not fully inserted
and locked into position.
• Push water tank down completely to lock into place.
• Machine needs to be descaled. • Refer to ‘Descaling’, page 12.
• Coee is ground too nely and/or
too much coee in lter basket and/
or over tamping and/or lter basket
is blocked.
• See below, ‘Espresso only drips from the portalter
spouts or not at all’.
Espresso only
drips from
the portalter
spouts or
not at all.
• Coee is ground too nely. • Use slightly coarser grind. Refer to ‘Setting the Grind
Size’, page 9 and ‘Over Extraction’, page 11.
• Too much coee in the lter basket. • Lower dose of coee. Refer to ‘Setting the Grind
Amount’, page 9 and ‘Over Extraction’, page 11.
• Coee tamped too rmly. • Tamp between 15–20kg of pressure.
• Water tank is empty. • Fill tank.
• Water tank is not fully inserted and
locked into position.
• Push water tank down completely to lock into place.
• The lter basket may be blocked. • Use the pin on the end of the provided cleaning tool
to unblock the hole(s). If the hole(s) remain blocked,
dissolve a cleaning tablet in hot water and soak lter
basket and portalter in solution for approx.
20 minutes. Rinse thoroughly.
• Machine needs to be descaled. • Refer to ‘Descaling’, page 12.
Espresso
runs out too
quickly.
• Coee is ground too coarsely. • Use slightly ner grind. Refer to ‘Setting the Grind
Size’, page 9 and ‘Under Extraction’, page 11.
• Not enough coee in the lter basket. • Increase dose of coee. Refer to ‘Setting the Grind
Amount’, page 9 and ‘Under Extraction’, page 11.
• Coee tamped too lightly. • Tamp between 15–20kg of pressure.
Troubleshooting










