User Manual

11
EN
CARE & CLEANING
CLEANING THE STEAM WAND
Run steam to clear milk
from wand after texturing
Wipe steam wand after
each use
Clean hole with pin Remove tip Soak tip overnight then
re-attach
STORING YOUR MACHINE
Before storing, press the POWER button to off,
turn the Control Dial to ‘Standby’ and unplug.
Insert all accessories into position or into the
storage tray.
Store upright. Do not place anything on top.
WARNING
Do not immerse power cord, power
plug or appliance in water or any
other liquid. The water tank should
never be removed or completely
emptied during decalcifying.
CLEANING FILTER BASKETS
Should the ne holes in the lters become
blocked follow the steps below:
1. Place the lter into the portalter. Run
water through the machine with the lter
and portalter, without any ground coffee,
in place.
2. A pin can be used to clear the lter
basket holes.
3. For a thorough clean of the lters, dissolve
a cleaning tablet in hot water and soak
lters overnight.
CLEANING THE OUTER
HOUSING/CUP WARMING PLATE
The outer housing and cup warming plate can be
cleaned with a soft, damp cloth. Then polish with
a soft, dry cloth.
Do not use abrasive cleansers, pads or cloths
which can scratch the surface.
CLEANING THE DRIP TRAY
The drip tray should be removed, emptied and
cleaned at regular intervals.
Wash the drip tray with warm soapy water, using
a non-abrasive washing liquid, rinse and dry
thoroughly. The drip tray base and cover are
dishwasher safe.
CLEANING THE STORAGE TRAY
The storage tray can be removed after the drip
tray is removed then cleaned with a soft, damp
cloth (do not use abrasive cleansers, pads or
cloths which can scratch the surface).