User Manual

6
GETTING TO KNOW YOUR NEW APPLIANCE
OPERATING YOUR NEW APPLIANCE
CUSTOM DESIGNED
ACCESSORIES
• Razor™ Precision Dose Trimming Tool
• Single wall lter baskets for freshly
ground coee
• Advanced dual wall lter baskets for
pre-ground coee
• Water lter
• Stainless steel milk jug
BEFORE FIRST USE
Conditioning the Water Filter
• Remove lter from the plastic bag and soak in
a cup of water for 5 minutes.
• Rinse lter under cold running water.
• Wash the stainless steel mesh in the plastic
lter compartment with cold water. Insert the
lter into the lter holder.
• Set the dial date 3 months ahead.
• To install lter, push down to lock into place.
• Slide the water tank into position and lock
into place.
NOTE
Do not clean any of the parts or accessories
in the dishwasher.
CLEANING ACCESSORIES
• Cleaning tool
• Silicon cleaning disk
• Cleaning tablets
FIRST USE
Initial Start Up
• Fill tank with water.
• Press POWER button.
• The machine will reach operating temperature
and go into ‘Standby’ mode.
Flushing the Machine
It is recommended to complete a water ushing
operation, without ground coee, to ensure the
machine has been conditioned.
When the machine has reached ‘Standby’ mode,
run the following 2 steps.
• Turn the Control Dial to the ‘Espresso’
position for 30 seconds.
• Turn the Control Dial to the ‘Steam’ position
to activate steam for 10 seconds.
• Repeat this cycle several times.
FILLING THE WATER TANK
• Fill the water tank with cold tap water to the
maximum mark on the side of the tank and
slide the water tank back into position at the
back of the machine.
• Plug the power cord into power outlet and
switch On at power point.
• Press the POWER button. The POWER
button surround will ash while the machine
is heating. When the correct temperature has
been reached, all the button surrounds on the
control panel will illuminate.