Operation Manual

6
WE RECOMMEND SAFETY FIRST
• Once the blender motor has
cooled down - the icon will
stop flashing and you will be
able to use the blender as per
instructions. At this point the
blender will be in standby
mode and you will only need
to press the button that you
require to start blending
again. However if you have
turned the blender off you
will need to switch it back on
and only if the icon has stop
flashing commence blending
as usual.
WARNING
Do not operate the blender
continuously with heavy load
for more than 10 seconds.
• CAUTION: In order to avoid
a hazard due to inadvertent
resetting of the thermal
cut-out, this appliance must
not be supplied through an
external switching device,
such as a timer, or connected
to a circuit that is regularly
switched on and off by the
utility.
• CAUTION: Ensure that the
blender is switched off before
removing it from the stand.
IMPORTANT SAFEGUARDS
FOR ALL ELECTRICAL
APPLIANCES
• Fully unwind the cord
before use.
• To protect against electric
shock, do not immerse the
cord, plug or motor base in
water or any other liquid.
• Do not allow the cord to hang
over the edge of a table or
bench, touch hot surfaces or
become knotted.
• Children should be
supervised to ensure that
they do not play with the
appliance.
• Do not use the appliance if
power cord, power plug or
appliance becomes damaged
in any way. If damaged or
maintenance other than
cleaning is required, please
contact Sage™ by Heston
Blumenthal
‰
Customer
Service on 0844 334 5110 or
go to sageappliances.co.uk.
• This appliance is for
household use only. Do not
use in moving vehicles or
boats. Do not use outdoors.
Do not use this appliance
for anything other than its
intended use. Misuse may
cause injury.