User Manual

● Apply to single color or dual color LED controller.
● Each remote can match one or more receiver.
● R bC 2032 attery powered.
● Operate with LED indicator light.
● Magnet on the back which can be easily stuck on back holder or any metal surfaces.
User Manual Ver 1.0.9
Technical Parameters
Input and Output
Warranty
5 years
Warranty
Operation temperature
Environment
IP20
IP rating
Ta: -30
O
C ~ +55
O
C
Model No.: R1/R2/RU4/RU8
Features
Page 1
1,4,8 zone dimming/10-key/Wireless remote 30m distance/CR2032 battery/Magnet stuck fix
10-Key RF Remote Controller
R1
R2
Output signal RF 2.4GHz( )
Working voltage 3VDC CR2032( )
Working current ＜5mA
Standby current ＜2μA
Standby time 2 years
Remote distance 30m(Barrier-free space)
Mechanical Structures and Installations
Match Remote Control (two match ways)
Use the controller’s Match key
Match:
Short press match key, immediately press on/off
key (single zone remote) or zone key (multiple zone
remote) on the remote.
The LED indicator fast flash a few times
means match is successful.
Use Power Restart
Match:
Switch off the power, then switch on power, repeat again.
Immediately short press on/off key (single zone remote)
or zone key (multiple zone remote) 3 times on the remote.
The light blinks 3 times means match is successful.
.
Delete:
Switch off the power, then switch on power, repeat again.
Immediately short press on/off key (single zone remote)
or zone key (multiple zone remote) 5 times on the remote.
The light blinks 5 times means all matched remotes were
deleted.
Delete:
Press and hold match key for 5s to delete all match,
The LED indicator fast flash a few times
means all matched remotes were deleted.
End user can choose the suitable match/delete ways. Two options are offered for selection:
R1,R2,RU4,RU8 10-Key RF Remote Controller
LVD RED
1 Zone Dimming
1 Zone CCT
RU4
4 Zone Dimming
RU8
8 Zone Dimming
11mm
135mm
40mm
Note: Before the first use,
please remove the protective film on the battery.
53 .50 mm
CR2032 Batter y
To fix the remote, three options are offered for selection:
Option 1: stuck the remote on any metal surfaces directly.
Option 2: fix the remote' back holder on the wall with two screws.
Option 3: adhere the remote' back holder to the wall with paster.
Back holder with magnet
Weight
0.040k g
Gross weight
Net weight
0.064k g
Safety and EMC
EMC standard (EMC)
ETSI EN 301 489-1 V2.2.3
ETSI EN 301 489-17 V3.2.4
Radio Equipment(RED)
ETSI EN 300 328 V2.2.2
Certification
CE,EMC,LVD,RED
EN 62368-1:2020+A11:2020
Safety standard(LVD)