User Manual

02
Getting Started
Before you begin installation, be sure to have the following:
PC or TV monitor
VGA or HDMI cable
Router (WAN)
Hard drive.If you purchased the system without hard drive, you must first install it.
If you do not have a hard drive, you will not be able to record and playback video.
Please see below for hard drive installation instructions
Do not attempt to install your cameras until you are able to view
images on your TV or PC monitor first.
Installing the hard drive – if your system has a pre-installed hard drive, please skip
this step and go directly the section below, Installing the NVR. If you purchased a
hard drive separately, it must be formatted after installed it. See the Frequently
Asked Questions section of this manual for instructions about how to format a hard
drive, refer the question, How do I format my new hard drive and check my hard
drive information?
1 Installing your Network Video Recorder System
Remove the cover from the unit,
and remove the top two screws
Remove the cover Insert the hard drive, secure it
to the bottom of the unit with the
four screws
Connect the data wire and
power wire as shown
Replace the cover and fasten screws