Installation guide

RouteRecorder® 4C Installation Guide July 2009
ROUTERECORDER 4C IG Ver 1.3.docx 3
Important Installation Precautions
Keep the following precautions in mind when installing
the RouteRecorder® 4C system:
 IMPORTANT: To reduce the risk of electrical shock,
disconnect the vehicle negative battery terminal during
RouteRecorder® 4C system installation.
 To prevent system damage, the main wiring harness
(Part Number SV-4CSENHRNS) must not be
connected to the vehicle electrical system until all other
components and cables are installed and connected.
 The ground wire of the main wiring harness (Part
Number SV-4CTHRNS) must be connected directly to
the vehicle chassis.
 Use care when affixing any device to a vehicle with
screws. Before drilling or inserting screws, ensure that
vehicle components such as the gas tank and airbags
will not be damaged by the drill bit or screw.
 To prevent system damage, use only the cables
supplied with the RouteRecorder® 4C system.
 Do not disassemble any component of the
RouteRecorder® 4C system.
Typical Installation
1. Select an appropriate mounting location for the
MDVR.
2. Refer to the following illustrations for:
 Surface-mount installation
 Flush-mount installation
 Installation using the VCR Lockbox Adapter
Bracket
Ï Surface-Mount Installation
Ï Flush-Mount Installation
Ï SV-DVR-LB2 Installation
NOTE: When mounting the RouteRecorder 4C unit in the
SV-DVR-LB2 lockbox as shown above, use the holes
provided in order to ensure access to the hard drive.
When mounting the RouteRecorder 4C “upside down” in
the SV-DVR-LB2 lockbox, use the slots provided and adjust
the unit’s position accordingly.
3. Connect system and peripheral devices to the MDVR
as directed in documentation for the devices.
Connecting Components
When connecting components, select inconspicuous
cable routes that do not interfere with driver or passenger
mobility and that prevent damage to the cables
Refer to Appendix A for illustrations of typical system
wiring and component connections of the main wiring
harness (Part Number SV-4CTHRNS).