User`s manual

UCIT Series User’s Manual
6
PTZ Control
Supporting PTZ control realized by local ad client software;
Parameter Configuration
Supporting parameter configuration functions for mobile
DVR coding channel;
G-Sensor
Embedded Accelerometer
Power
Input Voltage
8VDC - 36VDC
Output Voltage
+12V@4*0.5A; +5V@0.5A
Power
Consumption
<10W in normal operation; <0.5W in standby mode
Operating
Environment
Temperature
Normal Operating Temperature: 0-60 degrees Centigrade
Humidity
10% to 95% Relative Humidity
Dimensions
160(W) x62(H) x200(D) mm.
Weight
Net: 2200g, Gross: 3500g
1.3. Installation
1.3.1. Requirements
To ensure operator safety, device stability and extended service life, please follow the below
guidelines when installing and operating the device:
1) Power supply and grounding:
a) The direct input range of the power supply of the device is from 8VDC to 36VDC.
b) The device has internal capacitors that store power. Please disconnect all power
and wait 5 minutes before connecting any cameras, alarm inputs, or external
monitors.
c) Do not connect any other device in series with the UCIT.
d) For Alarm Input Signals, 2VDC or less is a low input and 5VDC-30VDC is high
input. 2.1VDC-4.9VDC are not supported.
e) Ensure ground on power harness is directly connected to chassis ground.
2) Humidity requirements:
a) The device should be installed in dry environment avoiding moisture. Do not install
the device in locations with the possibility of water accumulation.
3) Installation locations:
a) Physical location of installation should be in a secure location with the least
amount of vibration possible.
b) All power, camera, and alarm harness cables should be ran and protected to
prevent chafing, short-circuits, or other damage.
c) Avoid direct sunlight exposure.
d) Unit is to be installed either vertically or horizontally.