User`s manual

UCIT Series User’s Manual

“Threshold”: Set values of X, Y and Z directions within the range of 0.00g--9.99g, press

DEL to delete the original number and use numbers to enter new setting. A good

baseline for settings is 3.00g for each axis.

“Alarm Switch”: set whether to enable or disable G-sensor alarm, press [ENTER] to

input.

 Alarm on: In the recording status, when any of the directions of X, Y and Z exceed

the “Threshold”, the alarm recording and the alarm logs will be started.

 Alarm off: In the recording status, when any of the directions of X, Y and Z exceed

the “Threshold”, neither the alarm recording nor the alarm logs will be started.

“Adjust”: This calibrates the accelerometer. Use this option when the vehicle is not

moving.

Upon completion, press the Save button to save settings.

 Motion Detection

This option is not supported at this time.

MOTION DETECTION

OFF/ON

HIGH/MID/LOW

HIGH/MID/LOWCHI/CH2/CH3/CH4

CHI/CH2/CH3/CH4

AREA

ENABLE

LEVEL

CHANNEL

SETUP

SAVE