User`s manual

UCIT Series User’s Manual

Step 4. Install the rubber shock absorbing covers

Mount the rubber shock absorbing covers on both sides of the SATA hard drive, with the side

of the cover with the lug close to the PCB.

Step 5. Close the enclosure and fasten the screws

3.2. SD Card Installation

Open the hard drive lock with the key and remove the hard drive sled, then remove the 4

screws holding the SIM card cover. The SD card slot is shown in the figure below. Since the

SD card slot is close to the 3G module, to facilitate inserting and removing the SD card, it is

recommended to remove the 3G module before inserting or removing the SD card.

Press the card and pull

out the 3G module