Specifications

Safety Track 249 Main Street Belleville, MI 48111 888-286-9829
8
Unit Installation
Mounting DVR
Mount the DVR unit inside the vehicle, with the below considerations:
• Unit should be mounted in an area that has no exposure to potential moisture
• When mounting unit, choose a location that will deter operator tampering but facilitate access
to the CF cards should they need to be removed for manual review.
• All wiring harnesses should be protected with conduit, and rubber grommets should be used for
all through-metal runs to prevent chafing of the wires.
• Unit is to be mounted using a screw-type fastener. No adhesive or Velcro should be used.
Mounting Cameras
Mount the cameras in the areas that are to be monitored, with the below considerations:
• The Cameras are not to be installed in any location that will interfere with the
driver/operator’s direct line of sight.
• Outdoor cameras should use rubber grommets for all through-metal runs and sealed with a
silicone to prevent wind noise or moisture from entering the vehicle.
• Always dry-run your cables and connect the cameras to ensure they are recording what is
intended and at the right direction (e.g. not upside down).
• Interior camera cables should be tucked into interior panels/under carpet to prevent tampering,
damage, and potential interference with the driver/operator.
Mounting Optional Speaker and Microphone
If the optional microphone is being installed, install inside the vehicle with the below considerations:
• The microphone should be installed close to the driver/operator to ensure clear audio is heard.
The best place for microphone placement is typically the ‘A’ pillar of the vehicle.
• Speaker(s) should be mounted close to the driver/operator to ensure they can hear clearly
without having to distract themselves to focus on the speaker location.