Specifications
9100 Rear Unload --38--
GATE DELAY PACKAGE (#8100-GATE) GGA
KEY PART NO. DESCRIPTION
1 55-0095 1/8" to 3/8" NPT Reducer
2 30-0015 1/4x90 Degree Elbow
3 25-8095 Oil Reservoir Assembly
4 55-0097 3/8 to 3/8" Hydraulic Nipple
5 55-0094 Flow Control Valve
6 55-0096 3/8 NPT x 90 Degree Male Pipe
Elbow
7 25-8096 Gate Release Trip Arm Assem
-
bly
8 25-8092-1 Gate Regulator Top Shaft Assy.
9 25-8090-1 Top Cylinder Bracket Assy.
10 55-0093 Hydraulic Cylinder
KEY PART NO. DESCRIPTION
11 952-0007-1 7-1/4" Nylon Tie Strap
12 25-8098 Cable/Eyebolt Assy.
13 25-8097-1 Lower Sleeve Spacer
14 25-8093-1 Lower Shaft Plate Assy.
15 25-8095-6 Top Copper Line Assy.
16 25-8101 Ground Control Rod Assy.
W/Grip
17 51-0007 Handle Grip
18 933-3804 5/16 x 4” Eyebolt
19 825-25-1Z 1/4x1" Self Tapping Screw
GATE DELAY INSTRUCTIONS & ADJUSTMENTS
The purpose of the gate delay system is to hold the rear swinging gate in the open position until the apron has cleaned
all of the forage out of the box. By adjusting the flow control the speed in which the gate closes can be regulated. When
the flow control is properly adjusted the gate will slowly close as the remainder of the forage is being unloaded. Once
the box is completely unloaded the gate delay will reach a trip position with the trip arm moving the lower cylinder shaft
out of the horizontal slot and allow the gate to trip closed and latch. For proper operation adjust as follows. When the
gate is completely closed (tight to rear upright) the cable and eyebolt assembly should be adjusted so the cable has no
slack. Cable should be tight but not over tightened. If cable and eyebolt is over tightened the lower cylinder will trip out
of the L-shaped slot on the lower bracket prematurely and the gate will try to close before the cylinder is fully extended.
If the cable and eyebolt is too loose the lower cylinder will not trip out of the L-shaped slot and the cylinder will reach its
maximum stroke and the trip arm will still not be in the tripped position allowing the gate to close. The gate will be held
open by the top cylinder bracket and the bracket may become damaged over time. The eyebolt and cable will need to
be adjusted periodically to maintain proper operation.