Owner`s manual

9100 Rear Unload - 10 -
PRE-OPERATION
GENERAL
Whenever adjusting, cleaning, lubricating or otherwise
servicing this forage box, you must shutoff and lockout
power to the box. Because this box can be truck
mounted or powered by a tractor, methods vary. On
truck mounted units, the connection between the PTO
and box is permanently installed and not intended to
be disconnected. On trucks, disengage the PTO drive,
turn off the engine, set the parking brake, remove the
ignition keys and keep them in your possession to
prevent anyone else from accidentally applying power
to the box unexpectedly. For tractors, disengage the
hydraulics, turn off the engine, set the brakes.
Throughout this manual, when directed to shutoff and
lockout power, be familiar with the previously
described procedures for the type of machine you are
operating.
Be sure your forage box is properly mounted to the
truck frame or to the wagon running gear. Consult
your dealer if you have any questions about proper
installation. A tie down kit from the manufacturer and
illustrated in the parts listing of this manual is available
for wagon applications.
Hydraulic input to the 9100 forage box requires 35
GPM @3000 PSI. If truck mounted, install a relief
valve set at 3000 PSI. Engine RPM should be 1500
RPM. Set up hydraulic system on truck mounted units
with a 40 gallon reservoir minimum. Call factory for
further information.
WARNING: INSPECT REGULARLY THAT
ALL CONNECTIONS AND BOLTS ARE TIGHT AND
SECURE BEFORE OPERATING. FAILURE TO
HEED MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH.
Inspect the forage box for proper adjustments as this
will ensure maximum machine performance. See
“Adjustments” section. Grease and oil the forage box
as required. See “Lubrication” section.
WARNING: DO NOT OPERATE UNTIL ALL
SHIELDS AND GUARDS ARE IN PLACE AND
SECURELY FASTENED. FAILURE TO HEED MAY
RESULT IN SERIOUS PERSONAL INJURY OR
DEATH.
DECAL H.
PART #46-9100-3
DECAL K.
PART #46-9100-4
DECAL J.
PART #46-0001-26
DECAL L.
PART #46-8500-7