Instructions / Assembly

877.655.3443 www.eagleindustrialgroup.com Page 11
• Connect the center support (Not
included with 4x4) using the
remaining slot-head bolts and
wing nuts (Figure 23).
• Use a at head screwdriver to
fully tighten the bolts to the
wing nuts.
Attaching the Center Support
• Once the center support is installed go back and tighten the vertical posts to
the ceiling brackets (Figure 24).
FIG 23
FIG 24
Placing the Wire Decking
• Take the wire decking and place it on the rack unit (Figure 25).
• Wire decking remains in place by gravity and can slide freely side-to-side.
• There will be a small space between each deck (Figure 26).
• Take one last look at all of the rivets to make sure they have not backed out
during the installation process.
FIG 25 FIG 26