Instructions / Assembly

Page 10 www.eagleindustrialgroup.com 877.655.3443
NOTE:
• If the rivets are not seating correctly, check if the vertical posts are truly
vertical.
• If the vertical posts are at an angle, the rivets will not seat properly.
• Make adjustments to the placement of the vertical posts or ceiling brackets
if the vertical posts are severely out of alignment.
Attaching the Outside Frame
• Once all vertical posts are
in place, install the side
beams.
• Place the rivets of the beams
in the bottom 2 holes of the
vertical posts (Figure 19).
• Ensure the small lip is on the
top, and that the side beams
are on the inside of the
vertical posts (Figure 20).
• Use a rubber mallet to hammer
the rivets into the bottom
of the teardrop holes
(Figure 21).
WARNING: Opposite ends
may come loose when
hammering beams in place.
Use a helper to ensure rivets
do not come loose during the
seating process.
FIG 20
FIG 19
FIG 21
• Finish with installation of the
C Channel Beams.
• Line up the 45 degree on the
end of the small lip to the
same angle on the side
beams. Each corner should
look like (Figure 22).
FIG 22